Skip to content
Grochi · Neutral pet information from South Korea · English edition한국어
Grochi.English edition
Guaranteed analysis

Crude ash

Korean label term: 조회분 · Crude Ash · Also called: crude ash content (조회분 함량), ash (회분), Ash

Translated from the Korean edition · Editorial draft, not professionally reviewed. This page is an English translation of the Korean edition as checked on 2026-11-19. If the two differ, the Korean edition is the reference. 한국어판 (Korean edition)

Definition

Crude ash is a measured value of the proportion of inorganic (mineral) residue left after a feed is burned at high temperature, and on packages it is usually labeled as a maximum, "○% max.".

About Crude ash

Crude ash is the amount of ash left after a feed is burned at a very high temperature until all the organic matter is gone. The remaining ash is the sum of minerals such as calcium, phosphorus, magnesium, sodium and potassium, so it is used as an indicator of the total mineral amount in a feed. The "crude" (조, 粗) means that this value is an approximate figure obtained by an analytical method.

In Korea, Appendix 13 of the Ministry of Agriculture, Food and Rural Affairs notice "Standards and Specifications for Feeds (사료 등의 기준 및 규격)" includes crude ash among the registered components of compound feed for companion animals (애완용 동물). It is an item registered and labeled together with crude protein, crude fat, calcium, phosphorus, crude fiber and moisture. On official Korean sales pages, crude ash is observed to be written as "max." (maximum, 이하). Appendix 13-2 recommends that the registered component amount be registered within ±20% of the formulation design value or analyzed value (for example, if the design or analyzed value is 30%, register as 24.00 to 36.00%), and for components with a maximum amount (labeled max.) it places the phrase "up to 80% where possible" alongside (a recommended standard).

In its consumer guidance, US AAFCO introduces that ash is not among the 4 required guaranteed analysis items (crude protein, crude fat, crude fiber, moisture), and that ash is an item manufacturers write voluntarily and may be labeled as a maximum. Therefore on overseas products, crude ash may not be labeled at all.

The crude ash number is only the total of how much mineral is contained, and does not tell which minerals are present in what amounts. Information such as the calcium-to-phosphorus ratio or magnesium content cannot be confirmed from the crude ash number alone. Also, ash tends to be higher when there are many animal-derived ingredients that include bone, but the quality of ingredients cannot be judged from the number alone.

Crude ash is also an as-fed percentage, so wet feed with a lot of moisture gives a smaller number. When comparing feeds of different forms, try converting to a dry matter basis with the moisture removed. A simple judgment that low is good and high is bad has no basis, and for mineral control in particular medical conditions a veterinarian's judgment takes priority.

How it appears on labels

Crude ash on labels
On Korean labels등록성분량 항목에 「조회분 ○○% 이하」로 적힌다. (Written under the registered component amount heading as "crude ash ○○% max. (조회분 ○○% 이하)".)
On English labelsMay be written in the Guaranteed Analysis as "Ash (max.) ○○%" (not one of the 4 AAFCO required items).
Unit / basis% (percentage of weight as fed) · maximum (max.)

Which standard is it?

  • Korea: Appendix 13 of the notice Standards and Specifications for Feeds (사료 등의 기준 및 규격) includes crude ash among the registered components of compound feed for companion animals, and on official Korean sales pages it is written as "max." (이하).
  • Korea: Appendix 13-2 recommends that the registered component amount be registered within ±20% of the formulation design value or analyzed value (for example, if the design or analyzed value is 30%, register as 24.00 to 36.00%), and for components with a maximum amount (labeled max.) it places the phrase "up to 80% where possible" alongside (a recommended standard).
  • US AAFCO: It is not included in the 4 required guaranteed analysis items, and ash is introduced as an optional item that may be labeled as a maximum.

Common misconceptions

  • Crude ash means ash was added separately → Crude ash is a measured value of the amount of minerals left after burning the feed, and it is not an additive.
  • A feed with high crude ash uses poor ingredients → Crude ash is only the total mineral amount and does not directly show the quality of ingredients.

What to check on the label

  • Check that the label is a maximum (max.) and that it is an as-fed value.
  • For individual minerals such as calcium and phosphorus, check the separately labeled values rather than crude ash.
  • When comparing feeds with different moisture, try converting to a dry matter basis.

Related guides

Where was this checked?

Translated from the Korean edition · Editorial draft, not professionally reviewed. The Korean entry is an explainer newly written from these sources, not a full translation of them. Not a diagnosis, prescription or feeding instruction. Korean edition checked 2026-11-19 · no paid partnerships.

All glossary terms